Less Rebound, Greater Control

Less Rebound, Greater Control

Dead blow hammers reduce the post-strike rebound that is common with other hammers, allowing for better controlled hits to the workpiece.

Steel shot inside the head of the hammer reduces rebound.

 TEKTON Ball Peen Dead Blow Hammer steel shot

Less Rebound, Greater Control

Parts + Assembly

TEKTON Ball Peen Dead Blow Hammer parts and assembly

A. Flat Face / Canister

Single piece of steel with polished flat face and hollow canister

E. Handle

Solid steel rod

B. Shot Fill

Durable round steel shot

F. Anti-Twist Anchor Tab

Spot welded to handle

C. Ball Peen Face

Polished steel

G. Outer Jacket

Hot cast polyurethane

D. Roll Pin

Fastens ball peen face to canister

Polished Steel Faces

Each face is made of 4140 Chromium-Molybdenum steel, hardened to HRC 52.

TEKTON Ball Peen Dead Blow Hammer flat face

Flat Face

Ideal for driving punches or cold chisels, flattening sheet metal, and aligning heavy parts for assembly or welding.

TEKTON Ball Peen Dead Blow Hammer ball peen face

Ball Peen Face

Ideal for shaping sheet metal, peening rivets, and any job where a controlled, concentrated force is needed.

Durable Polyurethane Jacket

The hammer's thick outer jacket is made from hot cast polyurethane that's highly resistant to chipping, cracking, and tearing.

Durable Polyurethane Jacket

TEKTON Ball Peen Dead Blow Hammer polyurethane jacket

Nonslip Textured Grip

TEKTON Dead Blow Hammer nonslip textured grip

Nonslip Textured Grip

The contoured handle and its textured surface provide a comfortable, nonslip grip for hammering. The end of the handle is flared to prevent it from slipping out of your hand.